270900_00 | 09.2021
EDER Power Climber
16
EN
Inserting the rope
WARNING
Rope type
Only the official Eder climbing rope may be used for the EDER
Power Climber (see name plate). This rope is certified type A
according to EN 1891. Other rope types can lead to increased
wear, spinning or tearing.
Damage to the rope
Wear on the rope is normal. Therefore, the rope must be
replaced from time to time (see section Rope wear). However, if
the sheath is damaged, the rope must be replaced immediately.
Before each use, check the rope for possible damage.
Rope end knot
Make sure that the rope has a suitable rope end knot so that you
cannot go over the end of the rope when descending. The rope
end knot must be larger than the rope guide.
> Ensure that the climbing rope is securely anchored.
> Open the cover by pulling up the release
> Pass the rope as a loop through the rope guide.
> Place the rope loop around the rope sheave.
> Pull on the end of the rope to push the rope into the teeth.
> Close the cover
ATTENTION
Closing the cover
