edenox VERSO-400 HC, Instruction Manual

Page: 4 / 16

Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.
• Agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. The condenser is located at the
of the appliance.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to the Helpline.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care
not to damage the fins.
Fault Probable Cause Action
The appliance is not
working
The unit is not switched on Check the unit is plugged in correctly and switched on
Plug and lead are damaged Call agent or qualified Technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call agent or qualified Technician
The appliance turns
on, but the
temperature is too
high/low
Condenser blocked with dust Clean Condenser
Doors are not shut properly
Check doors are shut and seals are not damaged
Appliance is located near a
heat source or air flow to the
condenser is being
interrupted
Move the appliance to a more suitable location
Ambient temperature is too
high
Increase ventilation or move appliance to a cooler position
Insufficient airflow to the
fans
Remove any blockages to the fans
Appliance is overloaded Reduce the amount stored in the appliance
Factory default parameters
adjusted
Call agent or qualified Technician
The appliance is
unusually loud
The appliance is touching a
neighbouring object
Check installation position and change if necessary
The appliance has not been
installed in a level or stable
position
Check installation position and change if necessary
3
UK