PERFORMER X INTAKE MANIFOLD INSTALLATION
1.
Trim the upper edge of the supplied intake manifold gasket
(See
Fig. 4)
.
2.
Using the supplied gasket, install the Performer X manifold/throttle
body/fuel rail assembly onto the engine. Torque all bolts to 17
ft./lbs. in the sequence shown
(See Fig. 5)
.
Remember:
Remove the paper towels or rags before
installing the intake manifold.
Catalog #4754
Rev. 10/06 - RS/mc
Page 3 of 4
©2006 Edelbrock Corporation
Brochure #63-0255
3.
Re-connect all factory sensors and vacuum hoses. Re-connect the
factory fuel injector wiring harness to the stock fuel injectors, and
re-attach the harness to the fuel rail bracket. Re-connect the stock
throttle cable to the bracket and following the factory service
manual, adjust the throttle cable for proper operation.
4.
Connect the Fuel Filter to the fuel rail and reconnect the fuel return
line. Re-fill the coolant to the factory specified level.
5.
Turn the key to the engine “on” position and check for fuel leaks. If
leaks exist, turn key to “off” and repair leaks before continuing. If
no leaks exist, start the engine and check for water and/or fuel
leaks.
NOTE: After any installation, always repair any leaks
before driving the vehicle.
Torque all bolts to 17 ft./lbs
Fig. 5
Fig. 4
Trim off this
edge of the intake
gasket for all 92-95
vehicles
