background image

COPYRIGHT©EDECOA, ALL RIGHT RESERVED, PI-EU-Rev 2.6----English

13 / 14

The alarm sounds 5 times per

time, after 2 seconds, same beeps

again.

The alarm is beeping

repeatedly

The load AC exceeds the nominal

power by 120%. Short circuit in

connection.

1. Disconnect the inverter

2. Disconnect the load

3. Reduce load

4. Connect the appliance first, turn on the inverter

switch after turning on the appliance switch

Got 100VAC or so while testing

inverter's ground wire and

Neutral line ?

This voltage is an electromagnetic

induction voltage, there is no

current leakage.

This is normal. Inverter output communication does

not distinguish hotline and neutral line, if you need

to distinguish the hotline and neutral line, please

contact customer service or after-sales technology.

Output voltage below 220V AC?

A True RMS voltage meter is

required to properly measure

output voltage of modified wave

inverter

Test output voltage with a True RMS meter Try to

maintain the input voltage in the range of rated

power

Change the battery of the meter then test again.

18.

IMPROPERUSE OF POWER INVERTER

1. Reverse polarity: For the models which have reverse polarity protection, inverter's fuse will blow out to protect the other

part inside the inverter when the inverter is connected reversed. It is possible to damage the part of the positive and negative

terminals due to high current after a short circuit. It will not affect the normal use after changing the fuse. For the model

which is not equipped with reverse polarity protection, it is possible that the electrolytic capacitor and the Mosfet will burn

out. When this occurs, a crack sound can be heard and smoke will be seen coming out.

2. When the input voltage exceeds the allowable voltage range of the inverter, the electrolytic capacitor inside the inverter

will burn out. In this case, a crack sound can be heard and smoke will be seen coming out.

3. Heavy overload. The overload protection power of the inverter is 10% higher than the rated Watts, mainly used to start

some appliances which require high start current. It doesn't support a long-term use. If customer uses the inverter for long

period of overload, it may cause aging of electronic parts and rapid increase of machine temperature. In more serious cases,

the electrolytic capacitor inside the inverter will burn out. If so, a crack sound can be heard and smoke will be seen coming

out.

4. The power inverter is used outdoor during rainy days or when water gets into the inverter. Because the inverter is not

waterproof, water entering any electronic part will cause short circuit and corrosion of such electronic parts. Failure to dry

after water entry will cause the electronic components to burn. When this occurs, a crack sound will be heard and smoke

will be seen.

5. The inverter output socket or terminal can only be connected to the appliance with the matching voltage. If the customer

connects the 110-120V appliance to the 230V inverter outlet, it may cause the appliance to burn out.

6. The AC output can only be connected to the electrical appliances. If connected to grid or generator, it may burn electronic

components. When this happens, a crack sound will be heard and smoke will be seen.

Should any of above cases occur here is the proper operation: first turn the inverter off; then disconnect the battery cable;
finally disconnect the appliances when smoke dissipates. Please feel free to contact Customer Service for technical guide or
repair service. (When the part in the inverter burns out, a crack sound will always be heard and smoke seen. Please keep calm
and follow the step above. Attention: please don't use water to irrigate the inverter or it will cause more loss.

19.

DISPOSAL

Do not dispose the product in the household waste. Please dispose it according to the disposal regulations for electronic waste in

your country.

20.

WARRANTY

Warranty for the product is one year starting from the date of purchase.

Summary of Contents for DPM10















Reviews: