Printed in USA
TVW
©2009
Page 15
E-CPM-4-8-10-SL8-I-0309
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
Refer to the CPM-4, CPM-8, CPM-10, ScariLite-8 Assembly Instructions
booklet for suggested Cutter Drum setups.
Cutter Wheels
Use only EDCO approved cutter wheels. Cutter wheels for all application are available - sizes and types
vary. Complete information is available from EDCO.
CP-403:
Hardened steel spacers for use
with all cutter wheel set ups.
CP-404:
2-3/8” diameter -1” ID x 3/16” max.
depth of cut - 1/2” - hi-carbon cutters - use
on concrete 3500 PSI or less.
CP-404P:
Same as above, except teeth are
pointed to aid in removal of paint or similar
surface material - points wear and become
fl at. When this happens, use as you would
standard CP-404.
CP-405:
3” diameter - 1” ID x 3/16” - max.
depth 3/4” - hi-carbon steel cutters - use on
concrete 3500 PSI or less.
CP-405P:
Same as above, except teeth are
pointed to aid in removal of paint or similar
surface material - points wear and become
fl at. When this happens, use as you would
standard CP-405.
CP-404TV:
2-1/8” OD x 1” ID x 1/4” thk
6 point, tungsten carbide inserts. Use
for long life and fast removal of concrete,
asphalt or coatings.
CP-408TV
: 3-1/8” OD x 1 3/16” ID x
5/16” thk 8 tungsten carbide inserts.
Heavy duty cutter with oversized inner di-
ameter. Maximum cutter shaft diameter
1”. Heavy removal of concrete, asphalt or
coatings.
Hi Carbon Cutters:
Spacers:
Genuine EDCO Tungsten Carbide Cutters are
colored blue:
Figure 6
Figure 7
New CP-405
Cutter Wheel
Uneven wear on cutter wheel
caused by cutting too deep or
cutting very hard concrete
