ECTACO SpeechGuard
®
Travel Edition
User Manual
5
inappropriate external power supply may cause failure of the
device and will void the warranty.
• Unfix the rubber strip on the right-hand side of the device to
access the AC/DC adapter jack.
• Connect the AC/DC adapter to your device.
The red LED signal shows that the battery is recharging and the
green one shows it is charged.
MultiMedia Card (MMC)
ECTACO SpeechGuard
®
TL-2 MultiMedia Card is included in the
standard package. The card contains data necessary for proper
functioning of the device. You can copy the contents of the card
provided in the standard package to any other MMC or SD card
(up to 512 MB capacity) and then install your card in ECTACO
SpeechGuard
®
TL-2 – for example, if you wish to allocate more
space for your mp3 files.
The MMC slot is situated under the battery in the battery
compartment. If the MMC is not installed, please follow the steps
below to install it.
Note:
Always make sure the device is turned off before installing
or removing the MMC. Use the
On/Off
button to turn the device
off.
• To open the battery compartment (see
General View
), unscrew
two screws, holding the battery compartment cover.
• Remove the battery from the compartment.
• Slide the MMC into the MMC slot with the label face up and the
contacts face down.
• Insert the battery into the compartment and screw two screws
back.
Initialization
If you want to restore the default settings for your device or, in
the rare event of a program failure, to recover, you will need to
perform a reset procedure. This can be done in one of the
following ways:
