ECTACO
®
Partner
®
C-4ER
User Manual
7
of the battery and a resulting loss of data in RAM. To restore full functionality of
the device, recharge the battery as soon as possible.
How to Recharge the Battery
ECTACO
®
Partner
®
C-4ER is equipped with a jack for external power supply.
Only a special charger may be used with your ECTACO
®
Partner
®
C-4ER.
Use of an inappropriate external power supply may cause failure of the
device and will void the warranty.
The AC/DC adapter should provide 5V
and min 250mA DC.
•
Connect the AC/DC adapter to your device via the AC/DC adapter jack (see
General
View
). The battery charging process will start.
SD card
Before you start using your ECTACO
®
Partner
®
C-4ER, please make sure the SD
card (included in the standard package) is installed into the SD slot of the device.
If the card is not installed, slide it into the slot located on the lower edge of the
device
–
the contacts of the card face up (if the device is unfolded), label face
down. Push the card gently until it clicks into place. To eject the card, just push it
in slightly.
Initialization
The initialization routine is started:
when ECTACO
®
Partner
®
C-4ER is turned on for the first time;
after the system has been reset with the
Reset
button.
The
Reset
button is located on the left-hand side of the keyboard (over the
SHIFT key). It can be accessed with any thin object like a paper clip. Never
use a needle or pin for this purpose since it can damage the device.
•
If you see the
Initialize system? (y/n)
message, press the
N
key to abort
initialization and customization.
The
System initialized!
message indicates that system initialization has been
completed and the factory defined default settings have been restored.
Keyboard
The standard American QWERTY keyboard is combined with Russian layout.
•
Enter the desired symbol from the keyboard by pressing the corresponding
key.
