ECS Photon Extreme KN3 SLI2, Manual, Page: 43 / 106

3-14
Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for the
onboard parallel port.
Parallel Port Mode (SPP)
Enables you to set the data transfer protocol for your parallel port. There are four
options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port), ECP (Extended
Capabilities Port) and ECP+EPP.
ECP Mode Use DMA (3)
When the onboard parallel port is set to ECP mode, the parallel port can use DMA 3 or
DMA1.
Watch Dog Timer Select(Disabled)
This item enables or disables watch dog timer select.
SATA2 Controller (RAID Mode)
This item is used to set the mode of SATA2 Controller.
IDE HDD Block Mode (Enabled)
Enable this field if your IDE hard drive supports block mode. Block mode enables
BIOS to automatically detect the optimal number of block read and writes per sector
that the drive can support. It also improves the speed of access to IDE devices.
Press <Esc> to return to the Advanced Chipset Features page.
3.3-5 Power Management Setup
This option lets you control system power management. The system has
various power-saving modes including powering down the hard disk, turning
off the video, suspending to RAM, and software power down that allows
the system to be automatically resumed by certain events.
Power On After Power Fail [OFF]
ACPI Suspend Type [S3(STR)]
Power Management [User Define]
Video Off Method [DPMS Support]
HDD Power Down [Disabled]
HDD Down In Suspend [Disabled]
Soft-Off by PBTN [Instant-Off]
Resume By PCI PME [Enabled]
Resume By Ring [Disabled]
Resume By USB (S3) [Disabled]
Resume By PS2 KB (S3) [Disabled]
Resume By PS2 MS (S3) [Disabled]
Power-On by Alarm [Disabled]
Day of Month Alarm 0
Time (hh:mm:ss) Alarm 0 : 0 : 0
Item Help
Menu Level
Phoenix-Award WorkstationBIOS CMOS Setup Utility
Power Management Setup
F5:Previous Values F6:Performance Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
x
x