P6LX2-A User’s Manual
2:
Using Your Mainboard – 2.8
Cooling Fan Connectors
The is a cooling fan power connector on the mainboard that
supports a CPU cooling fan with power management features. If
you connect this type of fan, and the ‘CPU FAN Off In Suspend’
line in the CMOS Setup utility’s Power Management Setup sec-
tion is set to Enabled, the system will turn the fan off when the
system is in Suspend mode.
Modem Wake-Up
The J2 connector on the mainboard is for connecting a signal
cable from a modem that supports a modem ring system wake-
up feature. With such a modem installed and connected to the
mainboard via this connector, the system will wake up from Sus-
pend mode when an incoming call is received by the modem.
The ‘Ring-In Event’ line in the CMOS Setup utility’s Power
Management Setup section must be set to Enabled for this fea-
ture to function.
LAN Wake-Up
The J1 connector on the mainboard is for connecting a signal
cable from a LAN card that supports LAN wake-up via Intel WOL
(Wake-up On LAN). With such a card installed and connected to
the mainboard via this connector, the system will wake up from
Suspend mode when wake-up is initiated over a LAN.
If you install a LAN card with this feature the system power
supply must provide 5-Volt current greater than 700ma.
ATX Power Supply
With an ATX power supply, the system will turn the power
off automatically when exiting Windows95.
UltraDMA Hard Disk Drive Support
This mainboard supports hard disks that use UltraDMA data
transfer. You attach an UltraDMA drive to one of the IDE cables.
If you use the Optimum Settings feature in the CMOS Setup
utility the system will automatically detect the drive and config-
ure the system to use it.