ECS AMD690GM-M2, Manual, Page: 48 / 68

42
Using BIOS
ACPI Suspend Type [S3(STR)]
HDD Power Down [Disabled]
Video Off Option
[Suspend -> Off]
Video Off Method [DPMS Support]
MODEM Use IRQ [3]
Soft-Off by PWRBTN [Instant-Off]
ACPI XSDT Table [Disabled]
Resume Event Control
[Press Enter]
Power Management Setup
This option lets you control system power management. The system has various
power-saving modes including powering down the hard disk, turning off the video,
suspending to RAM, and software power down that allows the system to be
automatically resumed by certain events.
Item Help
Menu Level
Phoenix-Award WorkstationBIOS CMOS Setup Utility
Power Management Setup
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
HDD Power Down (Disabled)
The IDE hard drive will spin down if it is not accessed within a specified length of
time. Options are from 1 Min to 15 Min and Disable.
Video Off Option (Suspend —> Off)
This option defines if the video is powered down when the system is put into suspend
mode.
Video Off Method (DPMS Support)
This item defines how the video is powered down to save power. This item is set to
DPMS (Display Power Management Software) by default.
MODEM Use IRQ (3)
If you want an incoming call on a modem to automatically resume the system from
a power-saving mode, use this item to specify the interrupt request line (IRQ) that is
used by the modem. You might have to connect the fax/modem to the motherboard
Wake On Modem connector for this feature to work.
ACPI Suspend Type (S3(STR))
Use this item to define how your system suspends. In the default, S3 (STR), the
suspend mode is a suspend to RAM, i.e., the system shuts down with the
exception of a refresh current to the system memory.
1. When too many expansion cards occupy the memory size of shadow ram,
or the RAID Mode enabled, the function of LAN Boot ROM may not function
normally.
2. To create RAID setup, users MUST connect the hard-disks to SATA1 &
SATA2, or SATA3 & SATA4. Connecting the hard-disks to SATA1 & SATA3,
or SATA2 & SATA4, does NOT creat the RAID setup!
Use this item to enable and disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
LAN Boot ROM (Disabled)