Operation Directions
1. Application for an in-house call
If you want to call upon someone inside of your home, push the "Call" (Yellow Button)
on the wireless help caller. The dial console will give off a loud beep sound.
2. Application for an emergency call
When there is an emergency and you need help, push both left and right red buttons
together on the wireless help caller or push "Panic" button on the main unit for at least
one second. This will activate the main unit dialer, and the dialer will dial out the
emergency pre programmed numbers..
3. Application for canceling an emergency call
In case of mistaken informing or intended to cancel the emergency calling, just push
the "Call" (Yellow Button) on the wireless help caller or push the "Panic" button on the
main unit, and the main unit will stop the alarm right away.
4. Application for house surveillance
If you intend to check the situation at home from outside, call your home phone
number. The main unit will answer your call automatically after 5 rings. After your call
has been answered by the main unit, it will make ten beep sounds. You must enter your
4 digit password within the ten beep sounds, in order to listen to the situation at home
and proceed with two way communications. Press "#" key to end call.
5. For 2 Way Communication
The receiving party will hear10 continuous beep sounds following the message. If the receiver
intends to speak with the caller or just listen, press the "*" key. There will be the reminding
voices after communication 3 minutes. Press "9" key to repeat the message. Press "#" key and
hang up the phone to confirm the reception.
Note:
Inform the interested parties as to the procedure on how to reach you either by two way communication
or house surveillance.
6. The informing procedures after the alarm are being activated.
15 second alarm
Main unit dials each of the 5 emergency telephone numbers twice. If the receiving party
receives the message and presses "*" key to confirm, the main unit will only dial that number
once.
If the main unit does not receive the confirmation from the receiving party it will re-dial the
numbers again.
Wait for rescuers to arrive.
7. If the main unit has no AC power supply, the battery backup can be used to sustain the standby
operation for about 2 ½ to 3 hours. However when the battery is used as the power source, the
main unit will still dial out the emergency number for help, but it will not activate the siren or
two way communication
9
