Read This First
(continued)
General precautions
DANGER
Electrical Supply
Carefully read the rating plate located on the front panel.
The RetroAire replacement PTAC/PTHP must:
Be properly connected
•
to electrical supply with the
proper voltage as stated on the rating plate.
Be properly grounded
•
.
Use the properly-sized over-current protection
•
device
as stated on the rating plate. (
time-delay fuse/
HACR Breaker
)
Do not modify the RetroAire replacement PTAC/PTHP
Do not attempt to modify or change this unit in any way.
Tampering with the RetroAire replacement PTAC/PTHP is
dangerous and may result in serious injury or death. Tampering
voids all warranties.
Power Cord
The
power cord
supplied with the RetroAire replacement
PTAC/PTHP should be checked before every use. Follow the
instructions in the order listed on the device. Do not use the
product if the cord fails the test. A damaged power supply cord
must be replaced with a new cord from the manufacturer and not
repaired. The use of extension cords is prohibited.
Failure to follow these instructions can result in a fire, explo-
sion or electrical shock causing property damage, personal
injury or death.
WARNING — Safety instructions
Save these instructions —
this manual is intended as an
aid to
qualified service personnel
for proper installation,
operation, and maintenance of the RetroAire replacement
PTAC/PTHP.
Read all instructions
thoroughly and carefully before at-
tempting installation or operation. Install or locate this unit
only in accordance with these instructions. Use this unit only
for its intended use as described in this manual.
Turn off
the electrical supply before servicing the unit.
PTAC/PTHP chassis are heavy. To avoid injury, use assistance
when lifting.
Do not use the unit if it has damaged wiring, is not working
properly, or has been damaged or dropped.
Failure to follow these instructions may result in improper installa-
tion, operation, service, or maintenance, possibly resulting in fire,
electrical shock, property damage, personal injury, or death.
Recognize this symbol as an indication
of important safety information.
Inspection
Carefully check the shipment against the bill of lading.
•
Make sure correct chassis has been received (
•
as well as any op-
tions
).
Verify your equipment by using
•
“Model coding” on page 8.
Verify unit:
Unit size and type correct per submittal sheet and job requirements?
•
Voltage correct?
•
Verify options (if any):
Capacity, electric heat if used?
•
Hydronic coil included, if required? Piping located as required?
•
All other factory installed options installed, if any?
•
All field installed options included, if any?
•
Shipping damage MUST be reported to
the carrier IMMEDIATELY.
Examine the exterior.
•
Remove cover and examine
•
compressor and piping for signs
of damage.
Inspect each component for damage.
•
Concealed damage must be reported to the carrier
•
within
15 days
of the receipt of the shipment.
The carrier must make proper notation on the delivery
•
receipt of all damage identified and complete a carrier
inspection report.
The purchaser must notify ECR International’s Cus-
•
tomer Service department of all damage and is respon-
sible for filing any necessary claims with the carrier.
Customer Service : (800) 228-9364
Replacement Packaged Terminal Air-Conditioning / Heat Pump
• Installation, Operation, and Maintenance Manual •
P/N 240008034, Rev. D [7/29/2011]
3
Made in USA
