ECR International 18k, Installation, Operation & Maintenance Manual

Page: 18 / 20

PN 615000208, Rev A [06/30/2017]
ECR International, Inc.
2201 Dwyer Avenue • Utica, New York 13501
Phone: 800.253.9364 • Web: emiretroaire.com
Presents
Multi-Zone Programming Requirement
Follow the steps below to program EACH Air Handler
Control:
1.
Disconnect Power of outdoor unit and indoor unit.
2. Wait one (1) minute. Resume power to both indoor
and outdoor units.
3. Use remote to turn Indoor unit ON . With remote turn
Indoor unit OFF TO STANDBY MODE . Indoor unit
display will be blank.
4.
Remove batteries from Wireless Remote Controller.
5.
Press ON/OFF button and wait until Wireless Remote
Controller screen is blank.
Note
DO NOT POINT Wireless Remote Controller at the
Indoor Unit for steps 6 and 7.
6.
Install batteries into Wireless Remote Controller.
7.
Immediately press and hold MODE, FAN and TIMER-
ON button for 3 seconds until Wireless Remote
Controller enters ENGINEERING MODE .
Iverter Multi-Zone Wireless Remote Controller Programming Instructions
Note
POINT REMOTE at INDOOR UNIT for steps 8-12.
8.
Press UP button until Wireless Remote Controller
displays F4 .
9. Press MODE button, Wireless Remote Controller
displays 1 .
10. Press TIMER-ON button, while 1 is still shown on
display. Wireless Remote Controller will show F4 ,
Indoor Unit will beep once and display 01 .
11.
Remove batteries. Push ON/OFF button screen will be
blank.
12.
Install batteries to exit ENGINEERING MODE .
Operate A/C and Heat cycles to test remote.
Mode
On/Off
Fan
Timer On
Display
Iverter Multi-Zone Wireless Remote
Up
1 8