background image

22

FCC STATEMENT:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.) This device may not cause harmful interference, and

 2.) This device must accept any interference received, including interference that may cause undesired operation.

NOTE: 

To maintain compliance with RF Exposure guidelines, this equipment should be installed and operated with minimum 

distance between 20cm the radiator to your body: Use only the supplied antenna. FCC ID: 

2AAUI-GDIEXBDR310

.

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This 
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures: reorient or relocate the receiving antenna, increase the separation between the equipment and receiver, 
connect the equipment into an outlet on a circuit different from that to which the receiver is connected, consult the dealer or an 
experienced radio/TV technician for help.

IC STATEMENT:

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1.) This device may not cause interference, and 

 2.) This device must accept any interference, including interference that may cause undesired operation of the device.

PRODUCT USE AND PROTECTION:

Read and follow all instructions. Use only as intended.

The ECOXGEAR Bluetooth speaker is intended to be used indoors or outdoors and in land or water environments. The speaker has 
been tested to IP67 waterproofing standards, which means the speaker can be submerged in up to 3 feet of water for 30 minutes 
without any damage. However, the speaker is 

NOT

 intended for constant underwater use.

Always  make  sure  the  cap(s)  /  cover(s)  are  clean,  free  from  sand  or  debris,  and  correctly  fitted.  The  speaker  will  only  meet  IP67 
ratings  if  all  rubber  seals,  gasket(s)  and  cover(s) / cap(s) are in place. If you notice a muffling of audio  after  submersion, gently 
shake the unit to clear excess water. If your speaker is exposed to salt water, clean it thoroughly after use with fresh water.

The power cable and the unit with an improperly fitted cap are 

NOT

 waterproof.

To prevent fire or shock, do 

NOT

 attempt to charge this unit if it is wet or you suspect water has entered the unit. In this situation, 

please return the unit to Grace Digital for a free assessment. If we have found that the unit has carried water, we will repair or 
replace the unit free of charge.

SAFETY ADVISORY & WARNING:

Read and follow all instructions. Use only as intended.

CAUTION: Do 

NOT

 open to repair. A qualified technician must carry out repair work.

ATTENTION: Do 

NOT

 charge while the unit is wet. Towel dry the unit 

AND

 make sure all connections are dry 

 BEFORE 

plugging in the charging connector. Failure to do so may result in electrical damage to the unit and  

 may 

void 

the 

warranty.

WARNING:

 Cancer and Reproductive Harm - www.P65Warnings.ca.gov

WARNING: 

Danger of explosion if battery is incorrectly replaced.

CAUTION: 

The unit can be used with the main power cord disconnected, the unit is readily operable with the main power 
cord 

disconnected.

ATTENTION: Do 

NOT

 dispose of in a landfill. Contact Grace Digital at www.gracesupport.com or a certified recycling agent to 

dispose of the unit.

SAFETY:

This product has a limited life span of use and should be replaced when it shows obvious signs of wear. 

Do not modify or remove any original component parts of the speaker. Doing so could cause damage to the unit, allowing 
water to ingress. A unit with water ingress should not be charged due to potential risk of fire or shock.

Please exercise care and good judgment when using your ECOXGEAR speaker. Audio levels should be appropriate to your 
environment, comply with all local regulations, and always ensure that you can hear and be aware of any potential hazards 
around you.

3

16. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has

been damaged in any way, such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or 

moisture, does not operate normally, or has been dropped.

17. Keep a minimum distance of 5cm around all edges of the display for sufficient ventilation.

18. The ventilation should not be impeded by covering the ventilation openings with items, such

as newspapers, table-cloths, curtains, etc.

19. No naked flame sources, such as lighted candles, should be placed on the apparatus.

20. Operating Environment: temperature: 5 degree-35 degree, Humidity: 10% to 90%

non-condensing, altitude: 0-2000m. Safety way to remove the battery or the battery from

the equipment: Remove the old battery or battery pack, follow the steps in reverse order than

the assembly. To prevent contamination of the environment and bring on possible threat to

human and animal health, the old battery or the battery put it in the appropriate container 

at designated collection points. Do not dispose of batteries or battery together with other 

waste. It is recommended that you use local, free reimbursement systems batteries and

accumulators. The battery shall not be exposed to excessive heat such as sunshine, fire or the

like. Do not remove battery incorporated with product for your safety. If you need to replace the

battery, take it to the nearest authorized EcoBoulder Max service point or dealer for assistance.

Safety way to remove the battery or the battery from the equipment:

 Remove the old battery 

or battery pack, follow the steps in reverse order than the assembly. To prevent contamination of 

the environment and bring on possible threat to human and animal health, the old battery or the 

battery put it in the appropriate container at designated collection points. Do not dispose

of batteries or battery together with other waste. It is recommended that you use local, free 

reimbursement systems batteries and accumulators. The battery shall not be exposed to excessive 

heat such as sunshine, fire or the like. Do not remove battery incorporated with product for your 

safety. If you need to replace the battery, take it to the nearest authorized EcoBoulder Max service 

point or dealer for assistance. 

Correct Disposal of this product. This marking indicates that this product should not 

be disposed with other household wastes throughout the EU. To prevent possible 

harm to the environment or human health from uncontrolled waste disposal, recycle 

it responsibly to promote the sustainable reuse of material resources. To return your 

used device, please use the return and collection systems or contact the retailer 

where the product was purchased. They can take this product for environmental safe 

recycling. WEEE directive

Rating Label

The product rating label is located 

near the bottom of the back panel.

Summary of Contents for EcoBoulder MAX GDI-EXBDR310













Reviews: