SAFETY ADVISORY & WARNING:
Read and follow all instructions. Use only as intended.
CAUTION: Do
NOT
open to repair. A qualified technician must carry out repair work.
ATTENTION: Do
NOT
charge while the unit is wet. Towel dry the unit
AND
make sure all
connections are dry
BEFORE
plugging in the charging connector. Failure to do
so may result in electrical damage to the unit and may void the warranty.
PROPOSITION 65
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
WARNING:
2.5” Mounted Speakers have a built-in Lithium battery. The battery must
NOT
be used in or near an open heat source or excessive heat.
WARNING:
Danger of explosion if battery is incorrectly replaced.
ATTENTION: Do
NOT
dispose of in a landfill. Contact Grace Digital at
www.gracesupport.com or a certified recycling agent to
dispose of the unit.
ATTENTION: AC adapter is a device forming a part of the main plug; therefore, an AC
adapter can always be readily disconnected from AC socket-outlet.
SAFETY:
This product has a limited life span of use and should be replaced when it shows obvious
signs of wear.
Do not modify or remove any original component parts of the speaker. Doing so could cause
damage to the unit allowing water to ingress. A unit with water ingress should not be charged
due to potential risk of fire or shock.
Do not attempt to mount the unit except with the approved ECOXGEAR mounts. Doing so
could cause damage to the unit allowing water to ingress. A unit with water ingress should
not be charged due to potential risk of fire or shock.
Please exercise care and good judgment when using your ECOXGEAR speaker. Audio levels
should be appropriate to your environment, comply with all local regulations, and always
ensure that you can hear and be aware of any potential hazards around you.
You should always
1) Use the ECOXGEAR speaker in accordance with any music or noise rules and regulations.
2) Use the proper ECOXGEAR mounts if you intend to mount the unit.
3) Properly seal the ECOXGEAR prior and after each use when in humid or water
environments to avoid water damage to the internal components. Salt water / air is
particularly corrosive. Always make sure that the gaskets are sealed when in salt water
environment and the unit properly rinsed off after use.
4) Properly clean the ECOXGEAR and ensure the gaskets have no sand, dirt, or water on
them prior to storage or removing the back cover.
5) Store your unit with all caps properly sealed to avoid long term internal moisture damage
inside
your
unit.
6) Completely dry and clean your ECOXGEAR prior to attempting to charge the unit.
7) Return the ECOXGEAR to Grace Digital if you suspect water ingress into the unit or if the
unit has experienced a severe impact that may have affected the integrity of the unit to
take
on
water.
You should never
1) Never charge your ECOXGEAR if you suspect water has entered the device. Charging a
device with water inside could be potentially hazardous and cause fire or a spark.
2) Never use your ECOXGEAR if you have dropped it or thrown it against a hard surface
which may have destroyed the integrity of the speakers, housings, or gaskets. In the event
Turn on Bluetooth on your Bluetooth device (Smart Device) and
set the device in pairing mode. Available Bluetooth connections
shall appear. Select the ECOXGEAR speaker from the list of
discovered devices on your Bluetooth device. Wait for a few
seconds until the connection is completed.
NOTE:
Bluetooth connection feature is found in the Settings section
of most mobile phones and other Bluetooth enabled devices.
When the ECOXGEAR selection is made and the Bluetooth
connection is completed, your 2.5” Mounted Speakers will
announce: “Connection successful”
Once connected, select and play your desired audio.
Pairing Mode:
If the LED is not flashing or if you wish to place
your speakers in pairing mode, press and release the Bluetooth
button on the top panel. Your speakers shall announce “Ready to
connect” when ready to pair to a new device.
NOTE:
Your speakers shall sync & wirelessly pair with most
Bluetooth enabled devices. The unit remembers the last device
paired and will automatically search for previous connections
when the speaker is turned on or when a device comes back into
Bluetooth range. If a connection is lost due to range, the speaker
will look to re-establish that connection. If Bluetooth is turned off
on your Smart Device, the speakers may not automatically look
for the device.
RECOMMENDATION:
If you are not familiar with Bluetooth
pairing for your Smartphone or other Smart Device, refer to
the User Guide for your Smartphone to learn how to add and
pair a new device (2.5” Mounted Speakers for instance) to your
Smartphone using Bluetooth.
Bluetooth Pairing & Connections:
Once paired, should you have
an issue switching between Bluetooth connections between
devices, open the Bluetooth Section within the device currently
connected to the 2.5” Mounted Speakers and delete the
Bluetooth connection. The speakers will then be available to pair
and connect to an alternate Bluetooth enabled Smartphone /
Audio Device.
