Ecox EPLT, Owner'S Manual, Page: 3 / 16

3
REMOTE CONTROLLER
SPLIT AIR CONDITIONER
EPLT
HANDLING THE REMOTE CONTROLLER
Location of the remote controller.
Use the remote controller within a distance of 8
meters from the appliance, pointing it towards the
receiver. Reception is confirmed by a beep.
Keep the remote controller where its signals can
reach the receiver of the unit.
The air conditioner will not operate if curtains, doors or other materials block the
signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the remote
controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent the sunlight from
falling on the receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
The remote controller is powed by two dry batteries(R03/LR03X2) housed in the
rear part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new batteries,placing the(+) and (-)
ends correctly.
(3) Reattach the cover by sliding it back into position.
When the batteries are removed, the remote controller erases all programming. After
inserting new batteries, the remote controller must be reprogrammed.
Do not mix old and new batteries or batteries of different types.
Do not leave the batteries in the remote controller if they are not going to be used for
2 or 3 months.
Do not dispose batteries as unsorted municipal waste. Collection of such waste
separately for special treatment is necessary.
M OD
E
SW IN
G
TEM
P
SHO
RTCU
T
FAN SPEE
D
TIME
R O FF
RE SE
T
LO CK
LED FO LL
O W
M E
TIM E
R ON
TUR
BO
SELF
CLEAN
DIRE
CT
SLEE
P
FRES
H
CAUTIONS
CAUTIONS
NOTE
REPLACING BATTERIES
8m / 26Ft 2