6
NACM/EACM
ROOM AIR CONDITIONER - SPLIT WALL-MOUNTED TYPE
INSTALLATION PLATE MOUNTING
DRILL A HOLE IN THE WALL
INSTALLATION PLATE MOUNTING
The mounting wall is strong and solid enough to prevent it from
the vibration.
Fit the installation plate horizontally on structural parts of the
wall with spaces around the installation plate.
If the wall is made of brick, concrete or the like, drill five or
eight 5mm diameter holes in the wall.Insert Clip anchor for
appropriate mounting screws.
Fit the installation plate on the wall with five or eight type A
screws.
1
1
2
3
Mount the Installation Plate and drill holes in the wall according
to the wall structure and corresponding mounting points on the
installation plate. The installation plate provided with the machine
differ from appliance to appliance.
(Dimensions are in mm/in unless otherwise stated)
Determine hole positions according to left and right side of the
installation plate. The hole center is obtained by measuring the
distance as shown in the diagram above.
1
OUTDOOR UNIT
SETTLEMENT OF OUTDOOR UNIT
If an awning is built over the unit to prevent direct sunsight or
rain,be careful that heat radiation from the condenser is not
obstructed.
There should not be any animal or plant which could be affected
by hot air discharged.
Keep the spaces indicated by arrow from wall ceiling, fence or
other obstacles.
Do not place any obstacles which may cause a short circuit of
the discharged air.
Anchor the outdoor unit with a bolt and nut φ10 or φ8 tightly
and horizontally on a concrete or rigid mount.
The outdoor unit you purchase may be like one of the following.
Install the outdoor unit according to the dimension as indicated in
the table below:
C
A
Model A ( A: 710, B:250, C:100, D:110)
Model B ( A: 710, B:250, C:60, D:140)
B
D
85
150
205
930
275
790
NOTE
NOTE
NOTE
Correct orientation
of installation Plate
