20
TEMP+
Press to switch between Outdoor Temperature, Wind
Chill, Dew Point, Heat Index, 8 channel optional
Indoor/Outdoor Thermo-hygrometer, Circle Mode
WIND -
Press to switch between average wind speed and, wind
gust.
Press and hold for two seconds to switch the wind
direction to display in degrees or in letters.
RAIN/PRE
Press and hold for two seconds switch between Rain
and Pressure.
While in Rain mode, press to switch between Rain Rate,
Rain Events, Hourly Rain, Daily Rain, Weekly Rain,
and Monthly Rain
While in Pressure mode, press to switch between
Relative pressure and Absolute pressure
LIGHT
Press to adjust the LCD backlight brightness (high,
medium and off).
Press to exit the SET mode at any time.
TEMP+
(and)
RAIN PRE
Press this two buttons at the same time for 4 seconds to
activate BLE function for WiFi configuration (refer to
section 8.1.2)
Table 7: Key function
6.3 Setting mode
Note:
DST, Time Zone setting can only be programmed via WS View APP.
You will need to set time zone info properly if you have the console
connected to internet and these setting need to be adjusted for your setup,
otherwise console will be synchronized to default setting if you don’t setup
these parameters on the APP properly.
Press and hold the
MODE
button for two seconds to enter the Set Mode.
To proceed to the next setting, press (do not hold) the
MODE
button.
To exit the SET mode at any time, press the
LIGHT
button.
Table 8 summarizes the set mode sequence and commands.
