07
06
https://www.altonindustries.com
Product Installation
1.Handle disassembly and installation
1.1 lnstallation: Insert the handle connection tube to
the body component port, and hear the "click"
sound to mark the installation in place.
1.2 Disassembly: Use a suitable size screwdriver or Allen
key, insert the thin hole located in the upper back of the
body and press, while lifting the handle up.
2.Clean water tank installation: unscrew the cover of the clean water
tank in accordance with figure
2.1
Below and load clean water, tighten the cover
of the clean water tank clockwise in accordance
with Figure
2.3
Put it into the clean water tank in accordance with
Figure 2.4, and hear a "click" to indicate that the
installation is in place.
Figure2.1
Figure2.2
Figure2.3
Figure2.4
3. Dirty water tank installation:as shown in figure
3.1 The bottom of the dirty water tank is placed at the opening of the body, and then pushed inward, and the
"click" sound is heard to indicate a successful installation.
Figure3.1
Figure3.2
4.Roller brush installation:
As shown in the figure below, please align the groove on the right side of the brush with the drive shaft and
then press down on the left side of the roller brush until it is installed.
Press down
Align the drive shaft
5.Roller brush transparent window installation:
As shown in the figure below, the first roller brush transparent window cover below the snap good,
the latch to the brush on the buckle, hear the "click" sound indicates that the installation in place.
Latch
Buckle position
