6
Installation Steps
Step C - Install Faucet (packaged separately)
1. Slide the chrome base over the faucet stud so that it will sit below the faucet body (See Fig. 3).
2. Remove the hex nut from the end of the stud. Slide the spacer and lock washer onto the stud. Place
the hex nut back onto the stud.
3. Move faucet stud down into the mounting hole until the faucet base rests on the sink or countertop.
4. On the underside of the sink or countertop, slide the slotted washer between the countertop and
spacer. Tighten the hex nut securely.
5. Thread the 3/8” quick connect adaptor onto the end of the stud and tighten securely.
6. Connect the 3/8” blue tube by pushing the end into the 3/8” quick connect adaptor (See Page 7).
Figure 3
faucet
base
stud
slotted washer
spacer
lock washer
hex nut
3/8” blue tube from
filtration system
3/8” quick
connect adaptor
countertop
Step D - Make Tubing Connections
NOTE: Remove protective foam plugs before connecting tubes (See Fig. 4). Discard foam plugs.
1. Allowing some slack, measure and cut a length of yellow 3/8" tubing to connect between the supply
fitting and the filter system inlet, Figure 1. Cut the ends of the tubing square.
2. Insert yellow tubing all the way into the supply fitting and inlet fitting. Pull on the tubing to be sure that
it's held firmly in the fittings.
3. Repeat steps 1 and 2 to connect blue tubing from the faucet to the filter system outlet, Figure 1.
Tubing Connection (all push-in fitting locations):
This system includes push-in fittings for quick tubing connections. If working with the fittings, do the fol-
lowing.
continued on the next page
