8
Water Softener Features / Options
SET CAPACITY
The electronic control calculates this number, based on the initial programming. If
you want to change the capacity, do the following:
1
. Press and hold the SELECT button to display the screen shown in Figure 15.
2
. Press the SELECT button again to display the “Capacity” screen (See Figure
16).
3
. Press the
UP or
DOWN buttons to set either “CAP 1”, “CAP 2” or “CAP
3”. See the table below:
FIG. 15
FIG. 16
FIG. 17
4
. When the desired capacity is displayed, press the SELECT button.
5
. To return to the normal run (time of day) screen, press the SELECT button a
few more times.
VIEW DAYS TO RECHARGE
This “view-only” display shows the number of days until the softener’s next auto-
matic recharge. This display will not show if hardness was set to “OFF”.
1
. Press and hold the SELECT button to display the screen shown in Figure 11.
2
. Press the SELECT button two more times to display the “Days to Recharge”
screen (See Figure 17).
3
. To return to the normal run (time of day) screen, press the SELECT button
again.
Softening
Capacity
Frequency of
Regenerations
Water Usage
Salt
Efficiency
CAP 1
Lowest
Regenerates
most frequently
Uses
most water
Uses least salt
CAP 2
Medium
Medium
Medium
Medium
CAP 3
Highest
Regenerates
least frequently
Uses
least water
Uses most salt
