10
Power ON
Open the Top Cover. Move the Power
Switch to the “ ” position. The Control Panel
illuminates, DEEBOT plays a musical tune
and the AUTO Mode Button flashes. DEEBOT
is powered ON when the AUTO Mode Button
stays illuminated.
3
Place DEEBOT on the Charging Dock
making sure the Charging Contacts on
DEEBOT and the Charging Dock Pins make
a connection.
4
Charge DEEBOT
*
*
*
*
*
*
*
Please make sure the Power Switch is
turned ON before charging. (“O” indicates
OFF and “I” indicates ON).
Charge DEEBOT for at least 4 hours before
the first use. The AUTO Mode Button
flashes when charging, and goes out when
DEEBOT is fully charged.
Remove the Advanced Wet/Dry Reservoir
before charging DEEBOT.
Remove the robot’s battery if it will not be used for a long time. In case of battery leakage,
please remove the battery and wipe the battery slot clean while wearing protective gloves.
If the robot’s battery is fully discharged or not used for a long time, its capacity may decrease
and need to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after
charging for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT uses a long life battery and does not require frequent replacement. To replace the
battery, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Pack Screws, then remove the Battery Pack.
b. Insert new Battery Pack, re-insert and tighten the screws.
3. Operating and Programming
