EN
17
NO.
Malfunction
Possible Causes
Solutions
1
Remote Control
does not work
WINBOT 8 is cleaning. When
WINBOT 8 is cleaning, only the
START/PAUSE Button works on
the Remote Control.
Pause WINBOT 8 by pressing the
START/PAUSE button on the robot
or Remote Control. Other buttons
on the Remote Control will function
when WINBOT 8 is paused.
The Remote Control is not
paired with WINBOT 8.
WINBOT 8 arrives from the
factory paired with its Remote
Control. If the Remote Control
becomes un-paired or is
replaced, it can be re-paired.
Power ON WINBOT 8. At the same
time, press and hold START/PAUSE
Button on WINBOT 8 and Pairing
Button on the Remote Control.
Paring is complete when START/
PAUSE Button blinks RED, BLUE
and GREEN.
If the Remote Control does not
work and the Status Indicator
Light flashes RED, WINBOT 8
may need to be reset.
Reset WINBOT 8 by pressing the
RESET Button on the Remote
Control.
2
Status Indicator
Light flashes BLUE
after the product is
placed on the glass
The Cleaning Pad is attached
incorrectly and is covering
the Squeegees or the Edge
Detection Sensors.
Remove the Cleaning Pad and re-
attach it making sure it is placed
exactly within its Velcro area and
does not cover the Squeegees or the
Edge Detection Sensors.
Edge Detection Sensor
malfunction.
A. Remove the Cleaning Pad and
re-attach it making sure it does not
cover or affect the Edge Detection
Sensors.
B. Clean the Edge Detection
Sensors as described in section 4.
C. If the problem persists, please
contact Customer Service.
Fan malfunction.
A. Clean the Fan as described in
section 4.
B. If the problem persists, please
contact Customer Service.
Glass is too dirty for WINBOT 8
to adhere properly.
Clean a small area on the glass
before use and place WINBOT 8
there.
6. Troubleshooting
