ECOSTAR GRM 15, Installation, Operating And Maintenance Manual

Page: 15 / 31

08.10.2018 Rev. 04 14
7.
INSTALLATION
7.1. Burner Installation Picture
1- Flame tube
2- Connecting Flange (welded to the body)
3- Body
4- Gas intake flange
5- Fan
6- Installation bolt
7- Installation gasket
8- Combustion chamber wall
9- Insulation material
It is possible to perform installation in GRM Series Burners such that combustion air ventilator
and gas path are in different axes. Suggested method of installation is the installation, in which
gas line is parallel to the axis so that it is easier to interfere gas line equipment. The hole to be
opened on combustion chamber wall must be 20 mm larger than the diameter of the flame tube.
Installation surface must be coated with insulation material (9) in order for burner equipment not
to be affected by combustion chamber.
Use suitable compensator or flex hose while connecting the gas line reaching out the burner to the
burner gas line.
Do not lift the device holding from servomotor, gas valve, impulse pipes or pressure switch during
installation!
Clean the inside of fuel line thoroughly before installing the burner to the fuel line. Any damage
that may occur due to solid objects and metal particles from the fuel line shall not be covered by
our company.