Ecosoft WS1 CT, Manual, Page: 5 / 32

5
CONTROL VALVE PROGRAMMING AND COVER DRAWING MANUAL
ENG
The control valve offers multiple procedures that allow the valve to be modifi ed to suit the needs of the
installation. These procedures are:
• OEM System Setup
• Installer Displays & Settings (either 1-99 Days Between Regeneration option or 7-Day option)
• User Displays
These procedures can be accessed in any order. Details on each of the procedures are provided below
and on the following pages.
When in operation, normal user displays show the time of day or days remaining before regeneration.
When stepping through a procedure, if no buttons are pressed within five minutes the display returns to
a normal user display. Any changes made prior to the five minute time out are incorporated.
To quickly exit Installer Displays & Settings or OEM Setup, simultaneously press SET + ▼. Any changes
made prior to the exit are incorporated.
To reinitialize the control valve, check to make sure the valve is in the User Display. Then simultaneously
press SET + ▼ or unplug power source plug (4-pin connector) on the circuit board, wait 3 seconds and
plug back in.
Regeneration Cycles and Times for Different Programs Table 1
Program
All times in Minutes
С1
1st Backwash
С2
Regenerate
С3
2nd Backwash
С4
Rinse
С5
Fill
Р0 3 50 3 3 1-99
P1 8 50 8 4 1-99
Р2 8 70 10 6 1-99
РЗ 12 70 12 8 1-99
Р4 10 50 Skipped 8 1-99
Р5 4 50 Skipped 4 1-99
Рб 12 6 Skipped 12 1-99
Р7 6 Skipped Skipped 4 Skipped
Р8 10 Skipped Skipped 6 Skipped
Р9 14 Skipped Skipped 8 Skipped
NOTE: During regeneration the display will show C1, C2, etc. If the cycle is skipped, that cycle number
will not be displayed.
2. OEM GENERAL INSTRUCTIONS