www.ecoological.com ©2017 ECOOLOGICAL LLC AB Standard Assembly 10-2017
©2017 Ecoological
10/2017
Installation Manual-Standard
1.
Place AeroBox
™ in upright position and slide it in to the tailgate opening of your truck until the door of
the AeroBox™ would be flush with the tailgate when the tailgate is closed. The AeroBox™ should be
centered in the opening. Make sure there will be no interference with closing the tailgate by closing the
tailgate with the box in position.
2.
With the AeroBox™ in desired location, center punch a hole location roughly centered in the load floor
hand access cut-out and the channel at the base of the AeroBox
™ a
s shown below for both the left-side
and right-
side attachment locations. Drill a 3/8” inch hole through the floor of the AeroBox™ only. Make
sure hole location will land on flat area on truck bed surface (not on side of corrugation). If not, reposition
box.
3.
Using previously drilled holes as guides, drill through the truck bed floor (and liner, if present) at both
locations.
Do not move AeroBox™ until both holes are drilled.
Re-check alignment, if necessary.
4.
Remove the AeroBox™ and
re-drill/enlarg
e the holes in the truck bed with a 1/2” drill.
THUMBSCREW ATTACHMENT INSTALLATION
