Article-No.: 222421 // Index: 0.6
econ sens+
page 2 of 4
EN
Technical data of the econ sens+ basic device
Input voltage range
70
– 350 V AC (between U1,U2,U3 and N)
Power consumption
1.5 Watt max. (in Ethernet operation)
Power supply
direct (from measuring inputs U1 and U2)
Current range
0…400 / 1600 / 3200 A AC, depending on the
model of coils
Conformity with
EN 61000-6-1
EN 61010-1
Storage temperature range
-20... +70°C
Operating temperature
-20... +55°C
Humidity
max. 80 % rel. air humidity, non-condensing
Equipment class
IP20
Terminal clamping torque
max. 2.5 Nm
Cable cross-section of terminals
0.15
– 4 mm²
Consumption measurement accuracy
+/- 1%
Area of application
Two, three and four-phase systems with arbi-
trary load
Interfaces
Type S0-pulse:
Type RS485:
2 x S0-pulse output acc. to DIN EN 43864
1 x
100 BaseT-Ethernet (Webinterface, Modbus
TCP/Modbus Gateway)
1 x RS485 (Sensbus, Modbus RTU)
1 x 100 BaseT-Ethernet (Webinterface, Modbus
TCP/Modbus Gateway)
Delivery contents:
econ sens+
mounting rail assembly incl. current sensing coils
User information
Defects:
If the
econ sens+ / econ sens+ pro
does not start up properly once the operating voltage is
applied and if the
“Log” LED does not light up red, please re-disconnect the device from the
supply voltage. If this does not remedy the defect you can find more information and sup-
port at
or contact us by e-mail ([email protected]).
Safety information:
When working on the device, e.g. during service, disconnect the power! Installation may
only be performed by appropriately trained technical staff!
