
Installation & Operation Manual
ECON actuator Fig. 7917EX, type ELSA50 – 260
www.eriks.com
Rev. 0 – April 10
th
, 2019
5
Inspection, Storage, Transport
1.5.1
Receiving / Inspection
Carefully inspect the package for any damages resulting from shipping and report
all damages to the freight carrier and supplier.
After unpacking the product, please keep the cartons and any packing materials in
case of product return or replacement. Verify that the items listed on the packing slip
or bill of lading are the same as what was ordered. If there is any discrepancy,
please contact your supplier.
Verify that the technical data on the nameplate is in accordance with your purchase
order.
1.5.2
Storage
The actuator should be stored in a dry area with a relative humidity of less than 90%
(20 ± 5°C) and at a temperature between - 20°C to + 40°C (- 4°F to + 104°F)
The product shall be stored with suitable protection from corrosive substances,
which could damage the metal and insulating parts.
The metal plugs for temporary protection should not be removed until the actuator is
ready to be cabled. Use suitable flameproof cable glands to ensure IP rated
protection when installing. Please refer to section 1.2.2.
1.5.3
Transport
Attach ropes or hooks for the purpose of lifting or hoisting only to the housing and
not to the handwheel.
Actuators packaged in cartons can stand up to land, sea, or air transportation.
Packaged actuators shall be safeguarded from violent impact and strong vibrations
and be protected from rain or snow
.
1.5.4
Lubrication
The gear train has been sufficiently lubricated at the factory. No additional
lubrication is required.