17
Aus
An
Aus
An
HINWEIS:
Bei Verwendung des internen 250 Ohm Widerstands reduziert sich der maximale
Belastungswiderstand, um einen Strom von 20mA zu geben, von 1000Ω auf 750Ω.
Aktivierungs- / Deaktivierungsvorgang
1. Die Batterieabdeckung entfernen und die beiden Schrauben an der Oberseite des Gehäuses
lösen.
2. Die beiden Schrauben an der Unterseite oder am unteren Teil des Gehäuses herausdrehen.
3. Vorsichtig die obere Hälfte des Gehäuses von der unteren Hälfte lösen.
4. Abbildung 10a. zeigt die Position der Hart™-Drahtbrücken.
HART™-Widerstand
Platine
Abb. 10a.
4.4 Transmittersimulation
Damit der Kalibrator einen geeigneten Prüfstrom für einen Stromkreis anstelle eines Sensors
aufbringen kann, wie folgt vorgehen:
1. Die untere Anzeige im Hauptmenü auswählen.
2. Miliampersimulation als Primärparameter [mA 2W SIM] auswählen und den ge-
wünschten Strom eingeben.
3. Die Schleifenversorgung 24 V wie in Abbildung 11 dargestellt anschließen.
UUT
LOOP/
30 V-MAX
STROMVER-
SORGUNG
Abb. 11. Anschluss für die Transmittersimulation