Battery Replacement
Attach the security light to the rear housing cover
by positioning the security light over the
rear housing cover at an angle.
Engage the security light into the
grooves of the rear housing cover
and secure by twisting clockwise
until the security light is seated
vertically (
Fig. 5
).
OPEN
LOCK
UPWARD
Fig. 5
OPEN
LOCK
UPWARD
4
Remove the screw on the battery
compartment cover (
Fig. 2
). With
fingertips, pull up on the battery
compartment catch and pull outward to
remove the battery compartment cover
(
Fig. 3
).
2
Insert 3 new alkaline C cell batteries (not included)
into the battery compartment according to the “+”
and “-” markings near the battery drawings (
Fig.
4
).
Re-attach the battery compartment cover by aligning
the legs on the lower edge of the battery
compartment cover onto the fixture body and close
the cover until the catch at the top engages. Replace
the screw. Do not mix old and new batteries. Cold
weather may have a negative impact on battery life.
3
Fig. 5
Fig. 3
OFF ON
OFF
ON
ON
ON
Fig. 2
OFF ON
OFF ON
Fig. 4
Extreme hot or cold weather could affect the performance of the built-in sensors that detect
body heat. Certain winter clothing can shield a person’s body heat from the sensor during
extreme cold weather. During extreme hot weather, the sensor may not be able to distinguish
the difference between normal body temperatures and the surrounding high temperatures.
The sensor will begin working normally once weather conditions return to normal.
Troubleshooting Guide
Problem
Cause
Solution
Fixture does not light. 1. ON/OFF switch is not set correctly. 1. Slide ON/OFF switch to ON position.
2. Batteries are defective.
2. Replace the batteries.
3. Batteries are installed wrong.
3. Install the batteries correctly.
4. Battery compartment cover
4. Check battery compartment
is loose. cover and/or screw.
Light flickers on
1. Photo sensor is picking up
1. Remove batteries to reset
and off.
extraneous light.
photo sensor settings.
Fixture stays on
1. Heat source/reflective body
1. Remove heat source/reflective body
all night.
in detection area.
from detection zone or move fixture.
Motion sensor
1. Momentary heat source or
1. Turn sensor detection field
activates at random
reflective body. away from source.
or for no reason.
2. Minor sensor problem.
2. Remove batteries to reset sensor.
Motion sensor does
1. Batteries are depleted.
1. Check or replace batteries.
not activate at all.
2. ON/OFF switch is set to OFF.
2. Slide switch to ON position.
Detection range
1. Changes in meteorological
1. Adjust the position of the sensor.
varies from day
conditions.
to day.
Care and Maintenance
Periodically clean the fixture using a mild, non-abrasive glass cleaner and soft cloth. Do
NOT use solvents or cleaners containing abrasive agents. Do not spray liquid cleaner
directly onto the LEDs, fixture, diffuser, or wiring.
This fixture uses LEDs (light emitting diodes) to provide light. LEDs do not burn out like
traditional light bulbs and will last for 30 years or more.
Need Help?
C
C
C
In the event you are missing a part or have questions regarding installation
please visit our website or call the Customer Care Center.
- 3 -
