Transfer data to TTD USB Programmer
Aft er Completi ng the environment profi le programming, save the
modifi cati ons made on the programmer by clicking on ‘Save’ or by
selecti ng the ‘Save’ command in the ‘File’ menu. Then remove the
device from the USB port.
Transfer data to the TTD101 Thermostati c Head
Insert the connector into the corresponding socket in the head. See
fi gure below:
Note:
TTD USB Programmer must be disconnected from the compu-
ter while you are transferring heati ng profi les!
The display shows ‘P01’, which indicates ‘Profi le 1’. Select the en-
vironment profi le to be used by the thermostati c heads by turning
the wheel / roundel. You will be able to access any environment
profi les defi ned using the PC soft ware.
Press OK butt on to transfer the data to TTD101.
As soon as the thermostati c head is programmed, the display
returns to normal.
Important:
allow at least 10 seconds to transfer setti ngs.
Commissioning the Head for First Time
A new device will be set on factory setti ngs. Refer to TTD101 manu-
al for set-up procedure.
• Press the Menu butt on, rotate the roundel unti l PROG displayed,
then press OK to enter current date and ti me, which is automati -
cally transferred to the head from the TTD USB Programmer.
• The motor nows move to the ON positi on for valve installati on,
as shown on the display. For full instructi ons refer to the TTD101
manual.
• TTD101 is then ready to receive setti ngs from the TTS USB
Programmer.
Cleaning
Clean only with a dry or slightly damp cloth. Do not use solvents as
they may damage the device
Disposal of Device
Do not dispose of the device or packaging with the household
waste, they can be sent for recycling. Contact your local council for
advice on recycling centres.
Note:
TTD USB Programmer allows programming of TTD101 thermostati c
heads with the port incorporated.
Technical Data
Power Supply:
5V DC, max. 100mA via USB port
Serial Ports
:
PC:
USB 2.0
TTD101:
TTD101 programming port
System Requirements:
Windows XP
o
SP3
N° of ti me slots:
4 heati ng periods per day
LED functi ons:
Red LED on:
the data on TTD SUB Programmer
must be updated
Green LED fl ashes:
programmer is properly
connected to PC
Protecti on degree:
IP30 in accordance with EN 60529
Ambient temperature:
0°C to +50 °C
Storage temperature:
-20 °C to +70 °C
Material:
ASA Plasti c
Dimensions:
75 x 14 x 34 mm (H x W x L)
Warranty
htt p://www.ecodhome.com/garanzia-e-riparazioni.html
SmartDHOME Srl
www.ecodhome.com
For United Kingdom and Ireland, refer to:
www.ecodhome.co.uk
infosmartdhome.co.uk
www.ecodhome.com
Rev. 10/2014
P/N 01333-2500-00
