13
2.10 UVC function and specifications
Press the UVC bottom on remote controller to start or stop UVC sterilize function.
Note
：
Read the maintenance instructions before opening the device.
1.This appliance contains a UVC lamp.
2.Unintended use of the appliance or damage to the housing may result in the escape of
dangerous UVC radiation. UVC radiation may, even in small doses, cause harm to the eyes
and skin.
3.Appliances that are obviously damaged must not be operated. Prior to cleaning or other
maintenance, the appliance must be disconnected from the supply mains.
4.If applicable, precautions to be taken when replacing UVC emitters and starters;
5.Disconnect the power supply before replacing the UVC lamp;
6.Doors and access panels with a UV radiation hazard symbol may have UVC spectral
irradiance greater than 1,7 W/ cm2 and are equipped with an interlock switch to disconnect
UVC lamp power for safety. Don't go beyond;
7.It is recommended to disconnect the power supply before opening doors and access
panels with UV hazard symbols for user maintenance.
8.UVC barriers with UV radiation hazard symbols should not be removed;
9.For appliances fitted with UVC lamps, provide information on replacement of UVC lamps,
including model number and/or part number;
10.In the case of field installation, a factory-designated UVC sterilization lamp system
approved for use in this product shall be specified in the operating instructions by a
particular model;
11.Do not operate THE UVC lamp outside the device
