8
ENGLISH
A
B
C
D
E
Fig.6
A
B
Fig.7
ASSEMBLING OR REPLACING THE CUTTER
Make sure to have at hand a 6 mm spanner.
To assemble or replace the cutter, unscrew the retaining screw of the head (fig.8-A),
remove the worn cutter if already fitted to the head (fig.8-B) and insert the new cutter. Tighten
completely the retaining screw. If the cutter is replaced while working, make sure to clean thoroughly
the head by removing the residues of grass and dirt; ensure no residues enter the cutter
during the installation of the new one. It is recommended to clean and grease the housing
of the cutter each time the machine has been used (check “CLEANING THE HEAD”).
A B C
Fig.8
HOW TO ADJUST THE BLADE CUTTING DEPTH
To adjust the depth, act on the knob fitted
on the rear of the blade (fig.9-1). Loosen the knob a few turns
counter-clockwise, raise or lower the support of the two rear wheels (fig.9-
3) using as depth reference the graduated bar placed
on the support side (fig.9-2); once the necessary depth has been reached,
tighten completely the knob (fig.9-1) by rotating it clockwise. The numbers
on the graduated bar correspond to centimetres and range from 1 to 6.
Fig. 9
SPEED CONTROL
To adjust the cutting speed, act on the accelerator knob (fig.1 n.3) and
increase or decrease the engine rotations. Never adjust the speed by slipping slightly the clutch discs
