10
ENGLISH
HOW TO USE THE TWO‐CABLE BLADE
Laying two cables at the same time is required when it is necessary to go around trees,
flowerbeds, etc. (islands) away from the outer perimeter of the workspace. Proceed as follows (check
the sequence given in Fig. 15):
ADJUSTING THE BLADE DEPENDING ON THE CABLE THICKNESS
The machine is adjusted for 4 mm cables. To use
a cable having greater diameter, loosen the
two screws shown in the figure and raise the blade part a few millimetres.
Fig. A- B: proceed normally by ploughing one cable along the entire perimeter
Fig. C: once you have reached the point indicated in the figure, extract the blade from the soil, fasten
the cable with a stake and continue with the cable over the soil up to the next point.
Fig. D: in the point indicated in the figure, fasten the cable again on a stake
Fig. E: continue by normally ploughing the cable to create the island
Fig. F: once you have reached the point indicated, remove the stake previously fixed, and clean
the blade; fit the cable above ground in the blade as per the sequence (Fig. 14) below:
CLEANING THE BLADE
The cable laying machine is provided with a suitable tool (Fig.1-12
blade scraper ) for the cleaning of the soil residues which obstruct
the blade. Use it according to the image on the side.
Fig. 14
Fig. G: plough the two cables at the same time up to the point indicated in the figure. Fasten to a
stake the two cables and unhook the second cable from the blade.
Fig. H: continue the work by ploughing the perimeter cable as usual
