© 2022
Step 5 of 5
Order #XXXXX
Locked layer contains
placeholder marks.
Counter Top
When assembled
1.5” standoff
barrels
standoff
caps
standoff
caps
1.5” standoff
barrels
4.5” standoff
barrels
Transformer
hole for wire
management
To
Power
Note:
No standoff
cap for
middle
barrel.
* * *
Slide V20 Connector on
Standoff Barrel into groove
of horizontal extrusion.
Then turn barrel clockwise
to tighten in place.
Standoff Barrel Attachment
*
3
4
2
1
Backer Panel
TOP VIEW
CEI110
bolt &
wing nut
Lights
Backer
FRONT
Item
1/2
3/4
Qty.
1/1
1/1
Description
46”w CEI110 Horizontal Extrusion
30.5”h CEI110 Vertical Extrusion
+
-
Power
Female
Transformer
96W / 4 Amp / 24V
+
+
-
-
Lights
Male
Light to Light Attachment
Maximum of 7 lights per chain / 7 lights per Transformer
Light to Transformer Attachment
Steps:
1) Connect horizontals [
3,4
] between verticals [
1,2
],
sliding backer panel between verticals.
See
CEI-110 Corner Connection
detail.
2) Attach left & right cabinets to frame assembly [
1/2/3/4
]
using bolts & wing nuts.
3) Install
Counter Top
to assembly using standoff barrels.
See
Standoff Barrel Attachment
detail.
4) Connect power cords to Supernova lights as shown.
5) Apply SEG graphic to frame.
Refer to the SEG Installation general information page.
standoff
barrel
Turn to
tighten
CEI-110 Corner Connection
*
1) Insert TSRV2 and A1 Brackets
into milled groove of extrusion.
2) Slide connecting extrusion
over exposed end of brackets.
3) Use Set screws to secure
extrusions.
TSRV2
Bracket
(2 pieces)
A1
Screws
*
*
*
*
ECO-42C Reception Counter
