ECO POWER CIPR-15Z NG/LP, Installation And User Instructions Manual

Page: 8 / 26

2 Description of the product
2.1 Intended Use and Reasonably Foreseeable Misuse
The machine is a mobile, skid-mounted mobile generator. The Eco Power Equipment CIPR unit consists of
a trailer or skid with a gaseous generator, a control panel, and a sheet metal enclosure. As the engine
runs, the generator converts mechanical energy into electric power. Receptacles are present to power
auxiliary loads. The operator uses the control panel to operate and monitor the machine, with the digital
display showing all operating characteristics.
This machine is intended for prime rated power requirements and has been designed to operate 24/7.
This machine is also intended for the purpose of supplying electrical power to connected loads. Refer to
the product specifications for the output voltage and frequency of this unit, and for the maximum
output power limit of the Generator.
This machine has been designed and built strictly for the intended use described above. Using the
machine for any other purpose could permanently damage the machine or seriously injure the operator
or other persons in the area. Machine damage caused by misuse is not covered under warranty.
The following are some examples of misuse:
Connecting a load that has voltage and frequency requirements that are incompatible with the machine
output
Overloading the machine with a device that draws excessive power during either continuous running or
start-up
Operating the machine in a manner that is inconsistent with all federal, provincial and local codes and
regulations
Operating the machine outside of factory specifications
Operating the machine in a manner inconsistent with all warnings found on the machine and in the
Operator’s Manual
This machine has been designed and built in accordance with the latest Canadian safety standards. It has
been engineered to eliminate hazards as far as practicable and to increase operator safety through
protective guards and labeling. However, some risks may remain even after protective measures have
been taken. They are called residual risks. On this machine, they may include exposure to:
8