18
• Briefly press the ‘
x
’ button once.
• Select ‘H-Regler’ (H controller) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Hinzufügen’ (add) using the scroller.
• Briefly press the ‘
x
’ button once.
Afterwards, you can
‘
browse
’
through a list of the security codes of all the received room controls by turning
the scroller.
• Have the list of the security codes noted during the room control’s initial operation to hand (for example, table in
Appendix A) and select the security code by turning the scroller, for example ‘Code 0606’.
• Briefly press the ‘MAKRO’ button once.
By turning the scroller, you can now select from a list of pre-programmed room names.
The following room names are saved:
‘Arbeitsz.’ (work room), ‘Bad’ (bathroom), ‘Esszimmer’ (dining room), ‘Flur’ (hallway), ‘Gästez.’ (guest room), ‘Hobbyraum’
(hobby room), ‘Kinderz.’ (children’s room), ‘Küche’ (kitchen), ‘Schlafraum’ (bedroom), ‘WC’ (toilet), ‘Wohnzimmer’ (living
room).
If the desired room name is not there, select the room name which is most similar to the desired room name for the time
being.
This name can be changed later.
This can be done as follows:
• Use the scroller to select the room name concerned (for example, ‘Kinderz.’ = children’s room ).
• Confirm your selection by pressing the ‘MAKRO’ button.
• A cursor appears at the end of the LCD’s line (the blinking square is the cursor).
• If no changes are to be carried out, confirm the entry by pressing the ‘MAKRO’ button. The display briefly shows
‘gespeich.’ (saved).
• If changes are to be carried out, the cursor can be moved to the letter which is to be changed using the ‘
w
’ or
‘
x
’ button.
• The letter can be changed by turning the scroller.
• You can switch between upper and lower case, as well as special characters, by pressing the ‘
’ button. The
character set can be found in Appendix B.
• Once you have entered the desired name, this must be saved.
To do this, press the ‘MAKRO’ button. The display briefly shows ‘gespeich.’ (saved).
• Afterwards, the FHZ1000 is in the ‘Regler’ (controller) menu and the display shows ‘Hinzufügen’ (add).
• Repeat the steps described above until you have registered all the noted rooms.
• If no further room controls are to be registered, press the ‘
w
’ button three times briefly, one after the other.
Afterwards, the FHZ1000 is in the normal operating mode again
FHT 8W Heat Demand Relay
Installation and User Guide
Product Code EHC-FH06
1
