2
Fill Pump with water to prime: Ensure pump body is filled with water to discharge.
Motor’s Electrical Settings: Set motor to proper voltage.
Help Line: Call 1-877-326-3561 for assistance
STOP
Before you start
For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561
GENERAL SAFETY
SAFETY LABELS
Important Safety Instructions Carefully read and follow all safety instructions in this manual and on pump.
SAVE THESE INSTRUCTIONS – This manual contains important instructions that should be followed during installation,
operation, and maintenance of the product. Save this manual for future reference.
This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for personal injury!
Indicates a hazard which, if not avoided,
will result in death or serious injury.
Indicates a hazard which,if not avoided,
could result in death or serious injury.
Indicates a hazard which,if not avoided,
could result in minor or moderate injury.
NOTICE
indicates practices not related to personal injury.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
• Keep pump equipment out of the reach of children! Failure
to follow the directions given could cause serious risk to
individuals or objects.
• DO NOT work on pump until power is disconnected.
• DO NOT cut off ground pin or use an adapter fitting.
• DO NOT use an extension cord.
• DO NOT use this pump for water pressure booster appli-
cations. The pump housing is rated for 55 PSI MAX.
• The pump power cord should be connected to a sepa-
rately fused, grounded line with a minimum amp
capacity listed on page 6. It can be connected to a non-
fused breaker at the recommended amperes.
• ELECTRICAL PRECAUTIONS - Before servicing the
pump, always shut off the main power breaker and then
unplug the pump. Make sure you are not standing in
water and are wearing insulted protective shoes under
flood conditions. Contact your local electric company or
a qualified licensed electrician for disconnecting electrical
service prior to pump removal.
• Follow all local electrical and safety codes, as well as
the National Electrical Code (NEC) and the Occupational
Safety and Health Act (OSHA)
• Replace damaged or worn wiring cord immediately.
• Do not kink power cable and never allow the cable to
come in contact with oil, grease, hot surfaces, or
chemicals.
• Wire motor to correct supply. See motor nameplate and
wiring diagrams and check voltage of power supply.
• Unit must be securely and adequately electrically ground-
ed. This can be accomplished by wiring the unit to a
ground metal-clad raceway system or by using a separate
ground wire connected to the bare metal of the motor
frame or other suitable means.
• Do not disassemble the motor housing. This pump has
no repairable internal parts and disassembling may cause
leakage or dangerous electrical wiring issues.
• Make certain the electrical power source is adequate for
the requirements of the pump.
• Install pressure relief valve in the discharge pipe. Release
all pressure on system before working on any component.
• The following may cause severe damage to pump and will
void the warranty.
- Using an extension cord.
- Cutting off the ground pin or using an adapter fitting.
- Working on the pump or switch while plugged in.
- Removing motor housing, unscrewing impeller or
otherwise removing impeller seal
- Running the pump continuously.
- Pumping chemicals, corrosive liquids or anything beside
clean, clear water.
- Pumping gasoline or other flammable liquids.
• This pump is only to be used for water systems.
• Protect the power cable from coming in contact with
sharp objects.
• Do not run pump dry.
• Pump and plumbing must be full of water before startup.
• Do not pump water which contains sand, mud, silt or
debris.
• Be careful when touching the exterior of a motor. It may
be hot enough to be painful or cause injury.
• Do not allow pump or any system component to freeze.
To do so will void the warranty.
continued
