7
OPERATING THE UNIT
Removing the collected water
1. Pull out the bucket a little.
2. Hold the bottom of the bucket
with one hand and pull gently
backwards then up to remove.
3. Pour the water out and
replace.
When the bucket is full, the unit will automatically stop
running the water full light will flash and the display
will show P2.
Slowly pull out the bucket. Use the handgrip at the
bottom of the tank and carefully pull out straight
so water does not spill. Do not put the tank on the floor
because the bottom of the bucket is uneven and it might
spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The machine will re-start after a few seconds when the
bucket is correctly inserted.
Be sure to push the bucket gently all the way into the
unit. Forcing the bucket back into the machine may
cause damage to the tank or the unit.
There are two ways to remove collected water.
1. Using the bucket
NOTES:
,,
, ,
NOTE:
The continuous drainage hose must go downhill all the way
from the unit as the water has to drain away by gravity. Do not place
any part of the hose higher than the outlet of the machine or the water
will not drain away and internal damage could occur to the unit.
2. Using continuous drainage
If you are leaving the unit for long periods then it may be
beneficial to drain the water away continuously. This can
be done by inserting a pipe onto the machine.
Cut out the plastic blanking plug located on the side of the
machine (see picture on right). Attach a drain hose
(16mm internal diameter) and lead it out, downhill and away
from the unit.
Cut out the plastic
cover, then push
the hose onto the
drain hose outlet
that is behind it.
Fig. 5
Fig. 6
Fig. 7
