Raffaello Megaline
Espresso Coffee Machine
Installation
This equipment is to be installed to comply with the applicable federal, state or local plumbing
codes having jurisdiction.
The manufacturer has tried to foresee all possible
safety devices to ensure the safety of the users.
Anyhow different conditions of installation or of equipment moving can cause situations which cannot
be controlled or foreseen. Therefore it’s absolutely necessary to evaluate all remaining risks and to
care about the following:
•
Installation and maintenance MUST be carried out by technicians and service providers
authorised by the manufacturer.
•
Do not leave such packing items as plastic bags, Styrofoam, nails, etc. around because children or
other people could get hurt or damaged.
•
Any defect or discrepancy has to be notified immediately to the authorised persons for installation
and maintenance.
•
This machine is safe only when it has been correctly connected to an efficient grounding /earthing
system, implemented in accordance with the current safety regulations.
•
All electrical connections have to be effected exclusively by authorised and qualified technicians.
Any improper cable connection is forbidden.
•
Check the integrity of all components and do not install defective or damaged parts. Ask for
replacement.
•
Check that capacity of the electrical system is sufficient for the maximum rated power shown on
the data rating plate of the machine.
•
The customer has to protect the electrical feeding of the machine by means of a safety switch
system.
•
The machine has to operate with clean soft drinking water. Building up of scale will seriously
damage this equipment and can also cause injuries.
•
Before installation, the manufacturer strongly recommends to control the water supply system and
the electrical connections.
•
Check the mains water pressure which should not exceed 3,5 bar (0,35 MPa); otherwise it is
recommended to install a water pressure reducing valve. The minimum water pressure should be
at least 1,5 Bar (0,15 MPa).
•
The machine must be installed with an electrical switch with adequate fuses and safety devices.
•
Check the efficiency of the main drain. Then proceed with the connection of the water drain hose
to the machine. Check again pouring an adequate quantity of water directly into machine’s drain
tray (located under the drip tray).
•
This equipment must be installed on a flat, level and stable surface.
•
Handle the machine with care.
•
The machine has to be used with soft clean drinking water. If necessary install a water filter.
Specifications subject to change without notice.
10
