ENGLISH
Translation of the original German user manual
25
power cord). Activate the grind switch until no further grounds come out. If need be, manually clean the
spout again.
8. Open the slide lock of the bean hopper.
9. Re-calibrate the grind setting with the grinding time as preferred during the next few grinds. A coarser
grind can be compensated for by using more ground coffee or by tamping harder.
In case the grind setting of your grinder should change by itself after many grinding procedures, it is most
likely due to vibrations during grinding that have caused the bracket of the grind level adjuster to become
loose. In that case, please proceed as follows to correct the problem:
1. Switch the grinder off and unplug the power cord.
2. Loosen both screws (2.5mm Allen wrench), that are, or were, holding the grind adjustment bracket.
3. Position the bracket as closely to the gear wheel as possible and tighten both screws again.
11. CE CONFORMITY
This product complies with the following directives:
•
Low Voltage Directive:
2014/35/EU
•
Directive for electromagnetic compatibility (EMC):
2014/30/EU
•
Directive on the restriction of the use of certain hazardous substances in electrical and electronic
equipment (ROHS):
2011/65/EU
•
Directive
2012/19/EU
regarding waste electrical and electronic equipment
(WEEE Reg. no.: DE69510123)
Furthermore, the following regulations were followed:
•
Regulation (EC) No.
1907/2006/EU
on the Registration, Evaluation, Authorization and Restriction of
Chemicals (REACH).
•
Regulation (EC) No.
1935/2004
regarding materials and objects intended to come into contact with
food.
•
Regulation (EU) No.
10/2011
on plastic materials and objects intended for the purpose
•
of coming in contact with food.
•
Regulation (EC) No.
2023/2006
on good manufacturing practice for materials and articles intended to
come into contact with food.
For compliance, the following harmonised standards have been applied:
•
EN 60335-1:2012 + AC:2014 + A11:2014 + A13:2017 + A1:2019 + A2:2019 + A14:2019
•
EN 60335-2-64:2000 + A1:2002
•
EN 55014-1:2017 + A11:2020
•
EN IEC 55014-2:2021
•
EN 62233:2008
•
EN IEC 61000-3-2:2019 + A1:2021
•
EN 61000-3-3:2013 + A1:2019
Note: In the event of any changes made to the devices mentioned above without our explicit permission,
this declaration of conformity will become invalid.
12. DISPOSAL
This product complies with EU Directive 2012/19/EU and is registered according to WEEE (Waste Electrical
and Electronic Equipment).
Conformity
WEEE Reg.-no.: DE69510123
