Eclipse WC400 M Series User Manual Download Page 4

 

Remote Control 

(where fitted) 

 

If you have a remote control fitted to your opening roof, you will be able to use basic functions with the remote handset. 
Please see the remote control instruction leaflet that comes with the remote control unit. 

 

Smoke Sensor

 (where fitted) 

 

When the smoke sensor detects smoke (anytime longer than 1/10th of a second) the roofs will all open to the vertical 
position. The red light will flash briefly every 3 seconds. The roof will remain open until OPEN or CLOSE buttons are 
pressed. If smoke is still detected the roof will remain open. SMOKE will over ride RAIN even in RAIN mode. 

 

Power Cuts

 

 

If there is a power cut, the unit will switch itself back ON after power is restored.  When the power comes back on the 
unit will re-program itself by going through a "start-up" routine that will open and close the louvres.  The unit will come 
back  on  with  the  rain  protection  mode  switched  ON.  If  rain  is  detected  in  this  period  the  roof  will  close  and  only  go 
through the start up sequence once the rain sensor has dried out.  
If you have the Battery back up function in use, your system will continue to work for several days without 240V mains 
power. 
Please Note: Power failures/surges & storms can damage electrical equipment. 

 

 

Cleaning  

 

A build up of dirt or bird droppings may cause the roof to close when it is not raining. Therefore occasional cleaning of 
the 

Rain Sensor

 with soapy water is recommended. The Touchpad can be cleaned with a moist cloth but do not hose 

it down.

 

 

 

 

 

 

 

 

Notes 

 

If you have any difficulties with the controller please contact the company the unit was purchased from, if you cannot 
contact them feel free to contact the manufacturer through the website enquiry form at

  

 

 

www.hv.com.au

 

 

This unit has been tested for EMC compliance to EU (it carries a CE Mark); this is only valid when the Touchpad &/or the R/C 
Handset are the only accessible modules to the client. All other components may only be accessible for repairs and maintenance 
reasons. 

 

Summary of Contents for WC400 M Series

Page 1: ...s A key feature of the unit is a Rain Sensor that is mounted on the roof that will automatically close all roof banks when it starts to rain The M Series Roof Controller operates by use of the six buttons on the switch plate When the buttons are pushed individually they operate the primary functions of the unit When two buttons are pressed together additional secondary functions are operated You w...

Page 2: ...ce will turn OFF the rain protection system and the DP will go OFF Push the RAIN button again and the DP will come ON and it will be in rain protection mode once again When the rain protection system is ON the system is waiting until it rains When it starts to rain the raindrops falling onto the Rain Sensor which is mounted on the roof will cause all roof banks to close Once it stops raining and t...

Page 3: ...EN button 4 Press STEP to change the active roof to roof 2 3 4 etc 5 Press OPEN to get roof 2 3 4 to the desired position 6 Press AUTO then RAIN almost simultaneously Hold down the buttons If the controller has accepted this position the display will flash A for two seconds If not try steps 1 6 again You can test this by wetting the rain sensor plate manually allowing the roof to close in Rain mod...

Page 4: ...tion mode switched ON If rain is detected in this period the roof will close and only go through the start up sequence once the rain sensor has dried out If you have the Battery back up function in use your system will continue to work for several days without 240V mains power Please Note Power failures surges storms can damage electrical equipment Cleaning A build up of dirt or bird droppings may...

Reviews: