Secondary Functions
(Push & hold down buttons together)
AUTO+OPEN
Open all roof banks to the vertical position.
AUTO+CLOSE
Close all roof banks to the fully closed position.
ONE+STEP
Hold this down for 5 seconds to reboot the system
Setting the Rain Preferred Position
This must be set as it is the position that all the roofs will open to when the rain has stopped and the rain
sensor has dried.
1. Press AUTO and then CLOSE. (Just a split second between the two).
2. The roofs will close.
3. Open roof 1 to the desired position with the OPEN button.
4. Press STEP to change the active roof-to-roof 2, 3, 4 etc.
5. Press OPEN to get roof 2, 3, 4 to the desired position.
6. Press AUTO then RAIN (almost simultaneously). Hold down the buttons. If the controller has accepted
this position, the display will flash ‘A’ for two seconds.
If not try steps 1-6 again.
You can test this by wetting the rain sensor plate manually, allowing the roof to close in Rain mode, then
turning off the rain mode by pressing the rain button until the red light goes off. You have set the Rain Preferred
Position. Even when the power goes off the Preferred Position for Rain will remain in the memory of the
Controller.
Note: Touchpads can be in various types - Portrait or Landscape, and be Coloured or Silver/Grey.
