P0016-LI-03.01
47
LED Indications
The figure bellow shows the LED indicators for both the LED and LCD remote keypads:
Icon Name LED Description
Power
Green Mains AC power is present.
Ready
Green The system is ready for arming.
Armed
Green The system is armed (Away or Stay).
Fault
Yellow The system has one or more faults.
Bypass
Yellow One or more zones are bypassed.
Alert
Red
One or more faults/alarms require attention.
Alarm
Red
One or more alarms have occurred.
Fault & Status Messages
Faults and status messages may be indicated during the disarmed mode or after the user disarms the system. The table below shows the
message for both the LED and LCD remote keypads:
LCD LED
Description
*&+0,##
AC
Mains AC power is off.
11"/6 2)1
BF
The standby battery in the control panel has a fault.
%,+"&+" 2)1
LF
The on-board communicator has detected a fault with the telephone line.
+")*-"/
PT
The box tamper on the control panel has activated.
"))*-"/
BT
The bell tamper on the control panel has activated.
))+$&+""/
CE
Call engineer to reset the system.
"/3& "".2&/"!
CR
The service timer has expired and the installation company should be contacted.
:X&/"*,(")/*
SA
One or more 2-wire smoke detectors have activated a fire alarm.
:X&/"*,(" 2)1
SF
One or more 2-wire smoke detectors have a fault.
"6-!G,01
R?
Keypad ? is no longer reporting to the control panel.
"6-!G*-"/
T?
The box tamper on keypad ? has activated.
5-+!"/9,01
E1
Expander 1 is no longer reporting to the control panel.
5-+!"/9*-"/
t1
The box tamper on expander 1 has activated.
21-21G 2)1
O?
Output ? on the control panel has a fault.
,+"GGB)/*"!
??
Alarm activated on zone ??.
Resetting Faults & alarms
If a fault or alarm has occurred it can be reset as follows:
1.
Enter a valid access code, this will silence the alarm or
cancel the alert.
2.
Enter a valid access and press
R
to reset the system.
3.
Enter
*99
to exit the menu. If the fault is still present it
will still be indicated.
4.
Specifications
