9.
Transponder–1 Adjustment/Test (Standard System) with IFR-6000 Antenna
SUBTASK AMM-34-50-20-071-B-701-001-B
A. Begin adjustment/test as follows:
(1) Perform job setup, refer to
SUBTASK AMM-34-50-20-071-B-921-001-B
(2) Re-align the Transponder Test Set, IFR6000 antenna to point at the aircraft’s
Transponder–1 antenna (top of the center cabin/fuselage).
(3) Use the small rotary knob on the left PFD to select XPDR page.
NOTE: The XPDR select page will time out and switch back to the COM page after
30 seconds. The operator will have to select XPDR page from time to time
during this test. Make sure that Transponder 1 (XPDR 1) is selected as
ACTIVE transponder in STANDBY MODE.
(4) Scroll to FLT CTRLS using outer knob. Push inner knob to select. Scroll to the listed
ECB using outer knob and highlight. Push “COLLAR” soft key. Push “CONFIRM
COLLAR” soft key.
•
ECB - NOSE LDG GEAR (L AFT Bus)
•
ECB - L MAIN LDG GEAR (L AFT Bus)
•
ECB - R MAIN LDG GEAR (L AFT Bus)
(5) Scroll to ENGINE using outer knob. Push inner knob to select. Scroll to the listed
ECB using outer knob and highlight. Push “COLLAR” soft key. Push “CONFIRM
COLLAR” soft key.
•
ECB - L ENG FIRE EXTNGR (L FWD Bus)
•
ECB - R ENG FIRE EXTNGR (R FWD Bus)
(6) Clear any “MASTER CAUTIONS” and “MASTER WARNINGS” as needed.
(7) Set both left and right PFD baro set to 29.92 (in/Hg) on Autopilot Control Panel (ACP)
by pushing BARO SET knob.
B. Transponder-1 Setup
(1) Use the small rotary knob on the left PFD to select XPDR page.
NOTE: The XPDR select page times out and switches back to the COM page after
30 seconds. Select XPDR page from time to time during this test.
(2) Make sure that Transponder 1 (XPDR 1) is selected as ACTIVE transponder in
STANDBY MODE.
(3) Push CODE soft key on left PFD and enter the transponder code provided by the
control tower for this test. If no code was assigned, enter 1200.
C. Transponder-1 MODE A,C,S Test using Transponder Test Set, IFR6000
(1) Power up the Transponder Test Set (IFR 6000). After tester performs Self Test, push
SETUP button on the test set to bring up the SETUP-XPDR page. If necessary,
continue pressing SETUP button until tester cycles to SETUP-XPDR page.
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: 0001-0104, 0113-0115, 0120, 0123-0124
POST SB 500-99-002; AND 0105-0112,
0116-0119, 0121-0122, 0125-0262 PRE SB
500-99-005
34-50-20
CONFIG B
Page 519
Sep 30/20
© 2020 Eclipse Aerospace, Inc.
