CAUTION
●
Do not touch the heat dissipating part of the amplifier. Burns may result from the heat of this part.
●
If alkaline solution from alkaline dry batteries makes contact with your skin or clothes, flush clean with water. If
any of the solution gets in your eyes, also flush clean with water and then seek medical attention.
●
When disposing of lithium dry batteries, affix insulating tape to the positive and negative terminals, and after
they are insulated, dispose of them according to the local municipal ordinances. Shorts, fires and ruptures may
result from disposal if the terminals come into contact with other electrically conductive objects such as metal
parts, etc.
●
Do not short, disassemble or heat the batteries, or place them in fire or water. Fire and injuries may result from
battery rupture and leakage.
●
Do not use this main unit except for in-vehicle use. Electric shocks or injuries may result.
●
Be careful about the position of the volume control when turning the power source ON. Hearing damage may
result if a very loud noise is emitted when the power is turned ON.
●
Do not operate under abnormal conditions such as when the sound is broken or distorted. Fires may result.
●
This main unit uses invisible laser light. Do not disassemble or alter this main unit. If trouble occurs, contact the
dealer where you bought the main unit.
Altering this main unit may cause exposure to laser emissions (impairing eyesight), or result in accidents, fires
or electric shocks.
●
If the main unit is dropped or the cosmetics appear broken, turn off the power to the main unit and contact your
dealer. If it is used in this condition, fires or electric shocks may result.
●
Using the vehicle speed pulse signal, you can use the route guidance function even in locations where usually
no guidance is given (for example: in a tunnel). However, the accuracy of the guidance is not guaranteed since
the guidance is based on information about the road surface condition and vehicle speed.
●
Precautions for PND Operation
Do not remove the SD card while operating the PND.
Turn off the power to the PND, and wait at least 3 seconds after the display goes off, before removing the SD
card. Failure to do so may cause data in the SD card to be lost or damaged.
●
A CLASS 1 LASER PRODUCT label is affixed to the top of this unit.
●
In accordance with the European Directive 2002/96/EC (for Waste Electric and Electronic Equipment=WEEE), this
product, which is labeled with a crossed-out wheeled bin, may not be disposed of with household waste in
member states of the EU.
WEEE : Waste Electrical and Electronic Equipment
When disposing of this product in an EU member state, dispose of it properly in accordance with the laws of that
state, for example by returning it to the distributor.
WEEE has potential effects on the environment and human health as a result of the presence of hazardous
substances. You can help to eliminate these effects and to enhance reuse/recycling/ other forms of recovery by
your cooperation.
