5 / 16
=
2. Put together the keel, the water-proof rubber
gasket, and the ballast as shown and fasten with
the 5x25mm screw by using the included 4.0mm
allen key.
3. Attach and secure the keel and water-proof
rubber gasket to the hull using the 5x50mm
screw and the 4.0mm allen key.
4. Insert the rudder through the bottom of the hull
to the deck and through the rudder arm. Connect
with a clip making sure the rudder is able to rotate
freely. Then, insert the push rod through the
connector on the rudder arm. Make sure the rudder
is centered and tighten the allen screw with a
2.0mm allen key.
5. Install the cord holder to hull deck with two
PWA 2x10x8mm screws.
6. Unroll main sail and install 1 Luff ring in each
of the three
grommets. Slide the long mast through
1. Assemble the display base as shown
in the diagram by inserting the tubes into
the sockets. There's no need to glue the
parts together.
Assembly and Rigging Instructions
Summary of Contents for 650
Page 2: ......
