Eclipse 550, Maintenance Manual

Page: 7 / 10

AUTO-DEPLOYMENT OXYGEN MASK - INSTALLATION
AMM-35-20-13-041-801
1. General
A. This task gives procedures to install the dual auto-deployment oxygen mask and the
single auto-deployment oxygen mask.
B. There are two auto-deployment oxygen masks installed in two dual auto-deployment
oxygen mask container assemblies in the overhead console. Installation procedures for
the dual auto-deployment oxygen masks are the same and given for the forward.
C. There is a single auto-deployment oxygen mask installed in the single auto-deployment
oxygen mask container assembly in the Instrument Panel Right (IPR).
2. Job Set-Up
SUBTASK AMM-35-20-13-041-921-001
A. Make sure the aircraft is in same configuration as it was when the removal task was
completed. Refer to AMM-35-20-13-001-801 – Auto-Deployment Oxygen Masks -
Removal.
3. Procedure
SUBTASK AMM-35-20-13-041-411-001
(Refer to Fig. 401 .)
WARNING: OBEY OXYGEN SYSTEM SAFETY PRECAUTIONS WHEN WORK IS DONE
ON OR NEAR OXYGEN SYSTEM AND OXYGEN COMPONENTS. OBEY
THESE INSTRUCTIONS OR INJURY TO PERSONNEL AND OR DAMAGE
TO EQUIPMENT CAN OCCUR.
A. Install dual auto-deployment oxygen masks (3) as follows:
(1) Carefully place the passenger mask (3) , along with its lanyard cord, into the dual
mask oxygen container.
(2) Using a flat-blade screwdriver, install the passenger mask oxygen supply tube to the
valve by screwing the threaded mask tubing fitting (1) that is in the end of the supply
tubing.
(3) Insert the lanyard pin (2) into the valve.
(4) Repeat for the other mask as required.
(5) Install the container door.
(6) Center and secure the decorative panel to the mask container door.
Eclipse 550 Aircraft Maintenance Manual — 06-123838
Temporary Revision No. 35-1
EFFECTIVITY: ALL
35-20-13
Page 401-Inst
Dec 16/19
© 2019 Eclipse Aerospace, Inc.