EC-PM-530D User's Manual
- 70 -
z
Calculating the tearing position offset
As the black mark is on the tearing position, L=0, therefore, tearing position offset =
(67-0)/0.176=381 points.
z
Using the following command to set the tearing position offset
1D 28 46 <4> <0> <2> <0> <7D> <1>
z
Calculating the beginning print-position offset
(32-29) /0.176+381=364 points
z
Using the following command to set the beginning print-position offset
1D 28 46 <4> <0> <1> <0> <6C> <1>
z
After finishing the above setting, when printing every bill:
Use GS FF command to feed paper to beginning print-position;
Send the print data of every bill and print out the data line by line;
Use GS V m command to feed paper to tearing position, and then cut /tear off the bill.
[Example 2] Bill requirement: Tearing position is 8mm from the black mark position, and the beginning
print-position is 16mm from the tearing position.
z
Calculating the tearing position offset
As the distance between the black mark and the tearing position is less than L
0
(67mm),
therefore, tearing position offset = (67-8)/0.176=335 points.
z
Using the following command to set the tearing position offset
1D 28 46 <4> <0> <2> <0> <4F> <1>
z
Calculating the beginning print-position offset
(16-29)/0.176+335=261 points
z
Using the following command to set the beginning print-position offset
1D 28 46 <4> <0> <1> <0> <5> <1>
z
After finishing the above setting, when printing every bill:
Use GS FF command to feed paper to beginning print-position;
Send the print data of every bill and print out the data line by line;
Use GS V m command to feed paper to tearing position, and then cut/tear off the bill.
ABCDEFG
BCDEFGH
Black mark
Tearing position
Black mark detector
Q=
16
8