USER MANUAL
– CAVIX
Page
14
of
16
INMANUUIN185 Rev.2019.04.01 / ENG
CAVITATION APPLICATOR
Clean applicator after every session.
Disconnect the applicator before cleaning.
To clean use cotton or a cloth dampened in alcohol, to eliminate any product residue.
Do not use detergents, solvents or other abrasive agents.
Do not soak the applicator for cleaning since it could affect its normal working condition.
8.2 ELECTRICAL CONNECTIONS
Permanently check the condition of all the components and their ageing process.
Check that there are no:
Cables in bad conditions; cut or torn.
Bad connection of the cable with the socket.
Rusty pins in the connectors.
8.3 CHANGING THE FUSE
To avoid a waste of time for unavailability of the CAVIX we recommend having a spare fuse on
hand.
1) Disconnect the power cable from the electric current and from the device.
2) Under the connector for the power cable there is a small rectangular plastic piece where
the fuses are held. Using a screwdriver and pressing a little, remove the lid to replace the
damaged fuse.
3) Remove the damaged fuse and replace it with the spare fuse in the same socket. Use only
T4AL250V fuses.
4)
To close the socket, press till there is a “click” sound.
5) Connect the power cable.
9. TECHNICAL SPECIFICATIONS
Maximum power emission
3 Watts/cm2
Emission frequency
from 36 to 44 KHz
Operation mode
Continuous and Pulsed
Power supply
100 - 240 V
Nº of phases
1 (single phase)
Frequency
50 - 60 Hz
Grade of water protection
IPX0
Power consumption
120W
Fuses
T4A250V
Applicator
Corporal
Cooling system
Air (interior forced)
Dimensions
367 x 300 x 145 mm (Width x Height x
Length)
Weight
5,86 Kg (without accessories)
Operating conditions
10 - 40 ºC